Kia 2016 Sportage, Руководство по функциям и возможностям, Страница: 32 / 46

SPORTAGE
F E A T U R E S & F U N C T I O N S G U I D E
30
*IF EQUIPPED
OTHER KEY FEATURES
How to Sync Transmitter with HomeLink
®
*
Erasing programmed buttons:
If programming for the first time, begin with Step 1 (repeating this step will
delete all information) .
To program non-rolling and rolling code garage door openers and other devices:
1 . Press and hold the left [A] and center [D] buttons simultaneously until the
indicator light [C] begins to flash (to reprogram buttons, skip this step)
2 . Press and hold the desired button [A], [B] or [D] and hold the button on the
transmitter while it is approximately 1 to 3 inches away from the mirror . The
HomeLink
®
Indicator light [C] will flash rapidly once the frequency signal has
been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3 . Locate the “learn” or “smart” button on the garage door’s motor head unit .
Press and release the button and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink
®
button up to three times
Press and hold the left [A] and center [D] buttons simultaneously for
approximately 20 seconds, and then release both buttons within 30 seconds .
Operating HomeLink
®
:
Press one of the programmed HomeLink
®
buttons .
REMINDER: Mirror indicator light [C] will illuminate when automatic dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program
your vehicle’s HomeLink ® system, you may need to purchase a HomeLink Repeater Kit. For more
information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink
®
/ Auto-Dimming Rearview Mirror* is designed to
reduce glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters into one location .
•
To turn automatic dimming ON, press [~] button [F]
•
To turn automatic dimming OFF, press [~] button [G]
HomeLink
®
with Auto-Dimming
Rearview Mirror*
[A] HomeLink ® button
[B] HomeLink
®
button
[C] Indicator light
[D] HomeLink
®
button
[E] Glare detection sensor
[F] Automatic dimming ON
[G] Automatic dimming OFF
•
•
You can reprogram a single HomeLink
®
button by repeating Step 2
•
Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
A B C D E F G
D
D
E
F
F
G
G
C
C
C
B
A
A
A
A
B
D
D