Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Assembly Instructions
WorkUp
®
Fixed-Height Table
Model FX
January 2019
Tools Required
• #3 Phillips Screwdriver
• 5mm Hex Key
Note:
Before discarding any
packaging, confirm all components
received against the packing list.
Table assembly should be done on a
soft, protective surface.
Note:
When tightening the M8
screws, first twist all four screws
in “finger tight”. Then tighten the
screws one quarter turn at time
using a diagonal tightening pattern
as shown in Detail A. Repeat the
diagonal pattern until all four screws
are tight (Figure 1 & Detail A).
Feet-to-Columns Assembly
1. Set the column on end with the hole
pattern facing up (Figure 1).
2. Place the foot over the column
end so the column fits into the
square hole in the foot. The slotted
holes in the foot should line up with
the four holes in the column end. If
not the foot needs to be removed and
repositioned at 90 degrees
(Figure 1).
3. Attach the foot using four
M8 x 20mm screws and four 8mm
flat washers, tightening each screw
one quarter turn at a time in a
diagonal pattern until all four screws
are tight (Figure 1 & Detail A).
4. Thread leveling glides into the holes
at the ends of the foot (Figure 1).
Note:
If the roller foot option was
purchased, one foot will have
pre-assembled rollers.
5. Repeat steps 1 through 4 for the
second foot and column (Figure 1).
Figure 1
column
foot
leveling
glide
M8 x 20mm
screws
flat
washer
Detail A
