3. Rotate the bracket 90° to engage
it into the steel horizontal and the
base raceway. The center of the
raceway is now supported
(Figure 3).
Note:
Raceway side door
removed for clarity.
4. Cut a small notch in the base
raceway door as shown. This
provides clearance and allows
the door to close completely
(Figure 4).
Note:
Steel horizontal not
shown.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
W i r e Wo r k s B a s e Ra c e w a y C e n t e r S u p p o r t
A s s e m b l y I n s t r u c t i o n s
Figure 3
Figure 4
cut a notch
base raceway
