Instruct
®
Classroom Furniture - All Terrain
®
Instructor’s Desk
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Part # 80466R1
5. Carefully lay the worksurface
upside down on a soft,
protective surface. Position
the worksurface stiffener over
the pre-drilled holes in the
worksurface and secure using
#10 x
1
/
2
" Type AB screws as
illustrated (Figure 2).
6.
Position the support column
with the column plate over the
pre-drilled holes and secure
using eight #14 x
7
/
8
”
black
screws (Figure 2).
7. Twist the adjustable glide
into the bottom of the support
column until fully inserted.If
required, install a carpet gripper
into the bottom of the glide. Final
adjustment will be done at the
end of the assembly process
(Figure 2).
8. Place the modesty panel
mounting brackets over the
pre-drilled holes in the
worksurface and secure using
four #14 x
7
/
8
" black screws
(Figure 2).
9. Locate the landing pad on the
storage unit and place the
grommet into the top side of
the landing pad as illustrated
(Figure 3).
10. Position one table support
bracket over the pre-drilled
holes in the side of the storage
tower and secure using four
1
/
4
-20 x
5
/
8
" hex washer bolts as
illustrated. Repeat procedure for
second table support bracket
at adjacent side to the first.
(Figure 3).
Note:
Adjustment of glide on
table support column may be
necessary for table surface to
mate properly with table support
brackets.
Figure 2
Figure 3
adjustable
glide
carpet
gripper
table
support
bracket
#14 x /
7
8
”
black screw
table assembly
#14 x /
7
8
”
black screw
storage unit
¼-20 x /
5
8
”
hex washer bolt
table
support
bracket
grommet
landing pad
worksurface
worksurface
stiffener
#14 x /
7
8
”
black screw
support
column
modesty
panel
#14 x /
7
8
”
black screw
#10 x
1
/ ”
2
Type AB screw
column
plate
11. Carefully turn table assembly
to the upright position and rest
the table onto the table support
brackets installed to storage
unit. Align pre-drilled mounting
holes at underside of table with
holes in both table support
brackets and secure brackets to
table using four #14 x
7
/
8
" black
screws per bracket (Figure 3).
12. Twist adjustable glide at
underside of table support
column in or out to achieve level
table surface.
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2016 Krueger International, Inc. All Rights Reserved • Code KI-62120R3/KI/PDF/0316
