background image

Note:

The following instructions

illustrate how to install “canted”
and “straight” legs onto one
table.  See “Detail A” to 
determine and identify leg
style(s). Worksurface 
undersides are pre-drilled for
specific table leg configurations
to aid in assembly.  Your table
leg configuration may include
the four canted, four straight, or
a combination of two canted and
two straight legs. See “Detail B”
to view possible leg 
combinations.

1.  Carefully unpack worksurface

and table legs.  Place the 
worksurface top side down onto
a soft protective surface.  Set all
hardware parts and table legs
aside.  Identify the type(s) of legs
you have to assemble (Detail A).

2.  To assemble straight legs, begin

by locating the appropriate 
pre-drilled hole pattern on the
underside of the worksurface.
Remove the round mounting
plate from the top of the straight
leg.  Position the mounting plate
over the holes and secure using
four #12 x 1" Phillips screws as
illustrated (Figure 1).

3.  Next, secure the straight leg to

the mounting plate by engaging
the external threads at the center
top of the leg with the internal
threads in the leg mounting
plate.  Continue to spin the leg
in a clockwise direction until the
leg is securely tightened against
the underside of the worksurface.

4.  For canted leg assembly, 

position the leg over the 
pre-drilled holes at the 
underside of the worksurface.
Secure base of leg to underside
of worksurface using four 
#12 x 1" Phillips screws.  Repeat
for all remaining canted legs
requiring assembly (Figure 2).

A s s e m b l y   I n s t r u c t i o n s

I n q u i r e

®

Ta b l e

C a n t e d   a n d   S t r a i g h t   Fo u r- Le g

J u l y   2 0 1 1

Assemble units as described herein only. To do otherwise
may result in instability.  All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.

St

r

aight Leg

Canted Leg

Fou

r

 Canted Leg

s

Two St

r

aight &

Two Canted Leg

s

Fou

r

 St

r

aight Leg

s

Detail A - Leg Identification

Detail B - Typical Leg Configurations

leg mounting

plate

table top

#1

2

 x 1”

scr

ew

Figure 1

leg mounting

plate

s

t

r

aight leg

c

anted leg

#1

2

 x 1”

scr

ew

Figure 2

Отзывы: