1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2013 KI All Rights Reserved • Litho in USA • Code KI-62254R1/KI/GT/0513
Enlite
®
Nesting Table
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
14. To operate nesting mechanism
place hand in middle of table
top towards latch handle. Apply
downward pressure on top while
taking other hand and pulling
latch forward in lateral motion.
This allows the table top to
be released and able to rotate
upward (Figure 8 & Detail E)
Note:
If handle does not
operate smoothly to unlock
latches then handle screws
will need to be adjusted
(Step 5, Detail A).
15. Once the proper operation
of the latch release has been
confirmed, snap the screw caps
closed (Detail A).
16. With table top released,
rotate upward and lock on to
legs using installed leg clips
(Figure 9).
17. To close table for use, un-clip
worksurface from legs and
rotate downward slowly until
it’s on the leg assembly. Apply
slight downward pressure on
worksurface to lock latch in
place (Figure 9).
latch
release handle
latch
release handle
leg
assembly
leg
clips
Figure 9
Figure 8
Detail E
