Assembly Instructions
Enlite
®
Nesting Table
May 2013
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1. Carefully unpack all table items and
arrange parts on a flat, protective
surface. Position the worksurface
top-side down on a soft protective
surface, so pre-drilled holes face up.
2. Locate the worksurface support
block and #8 x 1” screw. Align the
mounting hole of the support block
to the pre-drilled hole in the center,
rear of the worksurface (for 60” &
72” tables). Then position the block
square to the surface, as illustrated
such that the rear horizontal frame
of the hinge assembly nests into the
support block, then tighten screw to
secure the support block (Figure 1).
3. As illustrated, position the main
hinge assembly onto the underside
of the table, over the two 8-hole
mounting patterns so the latch
release handle also matches up with
it’s two mounting holes (front of the
table underside). Notice also, that the
larger “9th hole” inside the 8-hole
pattern at each table end is oriented
to the front of table (Figure 1).
4. With main hinge assembly properly
positioned over mounting holes,
loosely twist in (do not tighten at this
time) eight #12 x
3
/
4
” wood screws,
at both ends of the hinge assembly.
Once all sixteen screws are in place,
assure that the two release handle
mounting holes line up at the center-
front and tighten all sixteen screws
down (Figure 1).
5. Mount the latch release handle to the
table underside, by first sliding two
1” diameter nylon washers under the
handle at the two handle mounting
holes. Place a black plastic screw
cap (with opened covers) over each
slot on the handle, align with the
mounting holes and insert two
1
/
4
-20
pan head Phillips screws through the
black caps, the handle slot, the 1”
washer and twist into the mounting
hole in the table top (Figure 1 &
Detail A).
Note:
Do not over-tighten the latch
handle screws. The latch release
handle must move freely for proper
operation of the latch release. The
screws have a locking patch material
applied, which helps hold the screws
in place even though they may seem
loose.
Note:
Do not snap the screw cover
caps closed until instructed to do so
at end of instructions.
Tools Required
• Powered drill driver (recommended)
• Driver bit extension (recommended)
•
3
/
16
” hex driver bit
• #2 Phillips driver bit
•
3
/
4
” wrench
• Rubber mallet (optional)
Figure 1
Detail A
#12 x / ”
wood screw
3
4
#12 x / ”
wood screw
3
4
larger
9th hole
8 hole
pattern
1” nylon
washers
1
/ -20
pan head screw
4
screw cap
latch
release handle
hinge
assembly
latch
release handle
#8 x 1 ” Phillips
flat head screw
worksurface
support block
(for 60 ”& 72” tables)
