8. Carefully tip the shelving unit into an
upright position. Note that two or
more assemblers are recommended
when multiple units are connected.
9. Bottom shelf. Insert (2) metal pegs
into pre-drilled holes just above the
base assembly. Lay bottom shelf with
routed side down and align onto metal
pegs (Figure 5).
10. Fixed center shelf. For 60", 72", 82"
and 96" high units, measure up half
way on the end panels. Within 6" of
this dimension, determine desired shelf
location. Rest shelf on four metal pegs.
Attach fixed shelf with #8 x
5
/
8
"
screws and (2)
1
/
4
" flat washers per
screw to the end panel (Figure 5).
11. Adjustable shelves. Insert (4) metal
pegs into pre-drilled holes at desired
adjustable shelf heights. Set each shelf
onto the metal pegs with notched side
down. Repeat for each adjustable shelf
(Figure 5).
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
Wooden Bottom Shelf
Base Assembly
Metal Adjustable Shelf
Metal Pegs
(4 per Shelf)
#8 x
5
/
8
" Screws
with two
1
/
4
" Washers
(4 per Shelf)
Fixed Middle Shelf
(Position Within 6"
of Middle of End Panels)
Metal Pegs
(2 per Bottom Shelf)
Metal Peg Locations
Front of Shelf
Shelf Detail
Fixed Middle Shelf
Screw Locations
CRMetalShlfBS5.eps
Screw
Washers
Figure 5
CrossRoads
®
Shelving - Single Face Metal with Back Stop
Assembly Instructions
