Right End Panel
Base Assembly
Back Panel
Side Groove
Glides (2)
#8 x
5
/
8
" Back Panel
Support Screws (2)
Back Panel
Shelf Back Inst.eps
Figure 5 & 6
Right End Panel
Base Assembly
Back Panel
Side Groove
Glides (2)
#8 x
5
/
8
" Back Panel
Support Screws (2)
Back Panel
Shelf Back Inst.eps
Figure 5 & 6
8. Repeat steps 5, 6 and 7 until all units
are assembled, finished with the right
end panel.
Note:
two or more
assemblers are recommended when
multiple units are connected.
9. For optional back panel, slide the back
panel into the side grooves of the
assembled units and slide into top
groove. Insert #8 x
5
/
8
" screws into the
groove directly below the back panel
to keep the panel raised off the floor
(Figures 5 & 6).
10. Carefully tip the shelving unit into an
upright position. Note that two or
more assemblers are recommended
when multiple units are connected.
11. Bottom shelf. Insert (4) metal pegs
into pre-drilled holes just above the
base assembly. Lay bottom shelf with
routed side down and align onto metal
pegs (Figure 7).
12. Attach wood cleats to the bottom side
of the fixed shelf using #8 x 1
1
/
4
" screws.
One cleat is needed for each side of
shelf. Rest shelf on four metal pegs.
Attach fixed shelf with cleats to the
end panels using #8 x 1
1
/
4
" screws
(Figure 7).
Note:
for 60” high units,
fixed shelf is approximately 43
1
/
4
" from
top of the bottom shelf. For 82" high
units, fixed shelf is approximately 50
13
/
16
"
from top of the bottom shelf.
13. Adjustable shelves for 82" high units
only. Insert (4) metal pegs into pre-
drilled holes at desired adjustable
shelf heights. Set each shelf onto the
metal pegs with routed side down
(routed grooves rest on pegs)
(Figure 7).
Note:
each 82" high unit
has one adjustable shelf and one fixed
shelf. Each 60" high unit has only the
one fixed shelf.
14. Attach notched rack to panels using
two #10 x 1
1
/
2
" screws.
Note:
for 60"
high units locate upper screw 36
3
/
4
"
above bottom shelf and 1
5
/
8
" from
back panel. For 82" high units, locate
upper screw 44
3
/
4
" above bottom shelf
and 1
5
/
8
" from back panel. Align the
bottom of the rack with the front edge
of the shared panel or 1" in from the
center of the arc of the end panels.
Attach with #10 x 1
1
/
2
" screw.
15. Set up to eight newspaper display
rods into notched racks.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
CrossRoads
®
Newspaper Display Unit
Assembly Instructions
Figure 6
Bottom Shelf
Base Assembly
Wood Cleats
(2 per Shelf)
Fixed Shelf
Notched Rack
Metal Pegs
(4 per Shelf)
Metal Pegs
(4 per Shelf)
#10 x 1
1
/
2
"
Pan Head Screws
Display Rod
#8 x 1
1
/
4
" Screws
Figure 7
Figure 5
