2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Aristotle
®
Casegoods - Aluminum Leg Table with Acrylic Panels
Assembly Instructions
4. Begin installation of acrylic modesty
panel(s) into aluminum legs by
removing the leveling glides
(Figure 3).
Note:
The Figure 3 assembly
illustration below shows the optional
second acrylic panel configuration.
Your installation may only specify
one panel and aluminum rail per
leg set.
5. As illustrated, slide acrylic panels
and aluminum rails into position
between the aluminum legs channels
(Figure 3). Adjust the screws
(pre-installed) in each end of
aluminum rail, if required to make
sure that the screw fits over the rib in
the groove of the leg (Detail A).
6. With the acrylic panel(s) and
aluminum rail(s) in place between
the legs, twist a lock nut onto a
#10-24 x
3
/
8
” cap screw and slide
the nut-end of the pair into the slot,
behind the rib of the groove in the
leg (Figure 4). Repeat this procedure
for the other leg, at the other end of
the aluminum rail (Figure 4 &
Detail B).
7. Using the Allen wrench provided,
tighten each #10-24 x
3
/
8
” hex head
cap screw into the lock nuts to
secure the aluminum rail(s) to the
legs (Figure 4 & Detail B).
Figure 3
Detail A
leveling
glide
screw
(in rail)
aluminum rails
aluminum
leg
aluminum
rail
screw
rib
aluminum
leg
channel
aluminum
leg channel
7HP36 - Hardware Pack
cap screw
#10-24 x / ”
3
8
4
lock nut
#10-24
4
Allen
wrench
1
adhesive
strips
8
Figure 4
Detail B
rib
hex head
cap screw
& nut
aluminum
rail
screw
(in rail)
aluminum
leg
acrylic
panel
#10-24 x / ”
hex cap screw
& lock nut
3
8
