background image

Assembly Instructions

All Terrain

®  

Wall Rail 

July 2012

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

1. Orient the wall rail with the top
hook edge facing up (Figure 1 &
Detail A). Slide a mounting bracket
into each end of the wall rail
extrusion, with the narrow portion
of the keyhole pointing up as
illustrated.

2. Position the mounting brackets to
the outside of the wall rail for better
stability (Figure 1).

se a spirit level under the

wall rail to assure the wall rail is
straight and m

3. Hold the wall rail with correctly
positioned brackets up to the wall at
1- / ” below the desired mounting
location. U

ake a mark at two

locations directly above each
keyhole location in the mounting
bracket. Remove the wall rail with
brackets, and confirm with a spirit
level that the marked holes are level.

4. Drill holes into studs, or into wall
locations as specified by customer
supplied fasteners then install
customer supplied fastening device
appropriate to the wall.

5. Line up keyholes in brackets with
fasteners, press the larger end of
the keyholes over the fasteners, and
pull down until is locked in snug.
Adjust fasteners if required for
secure fit.

Keyhole has a clearance of

½”and a keyway / ” wide.

1

13

8

64

Note:

Assembly Instructions

All Terrain Wall R ail

Detail A

AT-WlRail

hook

edge

(top)

wall

wall rail

extrusion

mounting

bracket

Figure 1

keyhole

fastener

(customer supplied)

wall rail

extrusion

mounting

bracket

1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI  54308-8100 • Tel 1-800-424-2432 • www.ki.com

© 2012 KI All Rights Reserved • Litho in USA • Code KI-61508R1/KI/PDF/0712

1. Orient the wall rail with the top hook 

edge facing up (Figure 1 & Detail A). 

Slide a mounting bracket into each 

end of the wall rail extrusion, with 

the narrow portion of the keyhole 

pointing up as illustrated. 

2. Position the mounting brackets to 

the outside of the wall rail for better 

stability (Figure 1).

3. Hold the wall rail with correctly 

positioned brackets up to the wall 

at 1

1

/

8

” below the desired mounting 

location.  Use a spirit level under 

the wall rail to ensure the wall rail 

is straight and make a mark at two 

locations directly above each keyhole 

location in the mounting bracket. 

Remove the wall rail with brackets, 

and confirm with a spirit level that 

the marked holes are level.

4. Drill mounting holes into studs, or 

into wall locations as specified by 

customer supplied fasteners then 

install customer supplied fastening 

device appropriate to the wall.

5. Line up keyholes in brackets with 

fasteners, press the larger end of 

the keyholes over the fasteners, and 

pull down on the wall rail/bracket 

assembly until it is locked in snug. 

Revove wall rail and adjust fasteners 

if required for a more secure fit.

Note:

 Keyhole has a clearance of ½” 

and a keyway 

13

/

64

” wide. 

Part #80500

Отзывы: