All Terrain
®
Mobile Furniture - Assembly Instructions
Fixed-Height and Pin-Height Adjustable Tables with Eight-Screw Base Attachment
3. Secure the bases on each side using
the screws provided (Figure 1).
4. Attach glides and/or casters to the
bases. See illustration and follow the
following guidelines below:
For 4CW - 4 casters
(2 locking & 2 non-locking):
Insert and tighten all four casters
using
3
/
4
" open-end wrench.
The two locking casters are to be
toward the front edge of the table
(Figure 2).
For 4GB - 4 glides:
Insert glides. To achieve the
standard pin heights (and the
same height as with casters) turn
the glides in until
1
/
2
" of the
telescoping sleeve is exposed
(Figure 2).
For 4MW - 2 glides and
2 non-locking casters:
Insert glides and casters as
previously described. The glides
should positioned towards the
front edge of the table (Figure 3).
5. For Pin-Height Adjustable Tables:
Check that both sides of the base are
set to the desired table height. The
pin should be in the center upright
hole for standard 29” tabletop height.
(Figure 4).
6. Carefully turn the table upright.
Check that the table is flat and level.
Adjust the glide heights to make
minor adjustments.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must
be tightened securely and must be checked periodically
after assembly. Failure to assemble properly, or to secure
parts may result in assembly failure and injury.
1
/
4
- 2 0 x
3
/
4
" s c r e w
Figure 1
n o n - l o c k i n g
c a s t e r
l o c k i n g
c a s t e r
glide
Figure 2
Figure 3
Figure 4
Part Number 13.7126
© KI 2002 Litho in USA Code KI-61331/KP402
