Ki Mobility 5 TTL, Инструкция пользователя и гарантия

Страница: 9 / 20

17
B. Transit Use (Continued)
DANGER: Failure to comply with transit use instructions, on pages 15 and 16,
could result in severe injury or death!
NOTE: To obtain a copies of RESNA or ISO standards please contact the
standards organizations below:
RESNA
1700 North Moore St., Suite 1540
Arlington, VA 22209
Phone: 703 ‐ 524 ‐ 6686
Fax: 703 ‐ 524 ‐ 6630
Email: technicalstandards@resna.org
ANSI/RESNA Standards:
RESNA WC ‐ 4:2012, Section 18:
Wheelchair tie ‐ down and occupant restraint systems for use in motor vehicles.
RESNA WC ‐ 4:2012, Section 19:
Wheelchairs used as seats in motor vehicles
RESNA WC ‐ 4:2012, Section 20:
Wheelchair seating systems for use in motor vehicles.
International Organization for Standardization (ISO)
ISO Central Secretariat
1, ch. de la Voie ‐ Creuse
CP 56
CH ‐ 1211 Geneva 20 Switzerland
Phone: +41 22 749 01 11
Fax : +41 22 733 34 30
Email: central@iso.org
ISO Standards:
ISO 10542 ‐ 1:2012 Technical systems and aids for disabled or handicapped
persons ‐‐ Wheelchair tie ‐ down and occupant ‐ restraint systems ‐‐ Part 1:
Requirements and test methods for all systems.
ISO 16840 ‐ 4:2009 Wheelchair seating ‐‐ Part 4:
Seating systems for use in motor vehicles.
ISO 7176 ‐ 19:2008 Wheelchairs ‐‐ Part 19:
Wheeled mobility devices for use as seats in motor vehicles.
V. SET UP & USE OF YOUR WHEELCHAIR
18
V. SET UP & USE OF YOUR WHEELCHAIR
C. Height ‐ Adjustable T ‐ Arms
1. Installation
a) Slide the outer armpost into the receiver mounted to the wheelchair frame.
b) The armrest will automatically lock into place. Check to make sure the
locking lever is as shown (Fig. 2 B)
2. Height Adjustment
a) Rotate release lever (Fig. 2 A)
b) Slide armrest pad up or down to desired height.
c) Return lever to locked position against arm post.
d) Push arm pad until upper arm post locks firmly into place. Check to make
sure the locking lever is as shown (Fig. 2 A)
3. Removing Armrest
a) Squeeze release lever (Fig. 2 B) and remove the armrest.
4. Replacing Armrest
a) Slide armrest back into receiver.
b) The armrest should lock back into place.
A
Fig. 2
B
DANGER: Failure to comply with the instructions above may result in the
armrest accidently disconnecting from the wheelchair and result in a fall or loss
of control and may cause serious injury or death.
DANGER: Never attempt to lift the chair by the armrests; they may break or
disconnect resulting in a fall or loss of control and may cause serious injury or
death.