4
7. THE INTERNAL ROOF RIDGE POLE SHOULD BE LOCATED INTO POSITION. THIS IS
LOCATED FROM THE INSIDE OF THE TENT BETWEEN THE TWO MAIN POLES BETWEEN
THE BEDROOM AREAS. LOCATE THE POLE INTO THE TWO POCKETS AND ADJUST TO
FIT –
THERE IS NO NEED TO OVER TENSION THE POLE – IT IS DESIGNED TO ASSIST WATER
RUNNING OFF THE ROOF AREA.
8. LOCATE THE FIBERGLASS BEDROOM ROOF POLES WITH METAL ANGLE SECTIONS
ON EACH END.
TAKE ONE OF THE ASSEMBLED METAL BEDROOM POLE UPRIGHTS AND CHOOSING
ONE SIDE OF THE BEDROOM ROOF POLE ENGAGE THE FERRELLED END INTO THE
OPEN END OF THE METAL ANGLE BRACKET ON THAT SIDE.
THE BASE OF THE UPRIGHT POLE THEN ENGAGES ONTO THE RING AND PIN FIXTURE.
THIS WILL BE LOCATED AT THE BASE OF THE FLYSHEET, NEAR TO THE SEAM
RUNNING DOWN FROM THE SLEEVE IN WHICH THE POLE IS LOCATED.
PLEASE NOTE
THAT THE ADJUSTABLE WEBBING STRAPS ATTACHED TO THE RING AND PIN SHOULD BE
SLACKENED OFF BEFORE INSERTING THE PIN INTO THE POLE. AFTER LOCATING THE PIN,
ADJUST THE STRAP WITHOUT OVER TIGHTENING.
EACH POLE RETAINING FIXTURE WILL HAVE A METAL RING WITH ONE OR MORE
RETAINING PINS ATTACHED TO IT ( DEPENDANT UPON MODEL ).
THE RETAINING PIN IS DESIGNED TO SLIDE UP INSIDE THE POLE ENDS THUS SECURING
THE POLE INTO PLACE.
USING A FURTHER METAL MAIN POLE UPRIGHT REPEAT FOR THE OPPOSITE SIDE.
REPEAT ITEM 8 AGAIN FOR THE OTHER BEDROOM.
RUNNING DOWN THE SEAM, FROM THE SLEEVE, ON EACH SIDE OF THE TENT YOU
WILL NOTICE THREE FLYSHEET TO MAIN POLE WEBBING CLIPS. ALL THESE, SHOULD
SIMPLY BE CLIPPED TO THE METAL MAIN POLES ALLOWING THE FLYSHEET TO TAKE
FULL SHAPE.
PLEASE NOTE THAT THESE ARE NOT INTENDED AS GUY POINT FIXINGS.
ATTACH ALL THE GUY ROPES TO ALL THE GUYING POINTS AND PEG SECURELY, AT A
SUITABLE DISTANCE FROM THE TENT. TRY NOT TO PEG TOO CLOSE TO THE TENT AS
THIS WILL NOT GIVE ADEQUATE SUPPORT AND MAY CAUSE THE FABRIC UNDER THE
GUY POINT ITSELF TO BECOME BAGGY OR LOOSE THUS ALLOWING INNER AND
OUTER TO TOUCH.
THE FRONT AND REAR GUY POINTS SHOULD BE ADEQUATELY TENSIONED TO
PREVENT THE POOLING OF WATER ON THE INDIVIDUAL ROOF SECTIONS.
THE PEGS PROVIDED WITH THIS TENT ARE STANDARD PEGS, SUITABLE FOR MOST
TERRAIN’S. HOWEVER THERE WILL BE OCCASIONS WHEN THE GROUND MAY BE FAR TOO
HARD OR ROCKY AND EQUALLY TOO BOGGY OR SANDY. IN THIS INSTANCE SPECIALIST
PEGS CAN BE PURCHASED THROUGH YOUR LOCAL RETAILER AND
SHOULD
BE USED
9. UNFOLD THE INNER TENTS AND PLACE IT INSIDE THE FLYSHEET BEDROOM AREA.
IF ‘D’ RINGS ARE PROVIDED ON THE INSIDE BASE OF THE MAIN POLE WEBBING
STRAPS SIMPLY CLIP THE INNER TO THE WITH THE “DOG LEAD” TYPE CLIPS ON THE
CORNERS OF THE INNER TENT. IF THE INNER TENT HAS PEGGING LOOPS SIMPLY PEG
THE INNER TENT INTO POSITION.
AN ELASTIC TOGGLE AND RING SYSTEM SUSPEND THE INNER TENTS FROM THE
INSIDE OF THE FLYSHEET. THE ELASTIC LOOPS AND TOGGLES ARE FOUND ON THE
INNER TENT WHILE THE SUSPENSION LOOPS AND RINGS ARE FOUND ON THE
FLYSHEET.
