Khyam
Khyam Kamper Cozi Instructions for the VW California
Step 1.
Remove the cover from its carry bag and lay
out on the ground next to the passenger side of
your vehicle, ensuring that the soft lining is
facing upwards and that the front of your cover
(with the third window) is facing forward. To
prevent the cover getting dusty or dirty we
recommend placing a groundsheet on the
floor first.
Step 2.
Take hold of the white beading at the front
corner of your cover, which should be nearest
to your vehicle, and begin to feed the beading
in to the aluminium awning rail which runs along
the passenger side of your vehicle. Start at the
rear and feed it along until the cover is
attached from front to back. The cover should
hang down with the soft lining facing out.
Step 3.
Open the front passenger door and stand on
the step, then gather as much of the cover as
possible and sweep it across the roof of your
vehicle. Go around to the driver’s side and pull
the cover across so that it
doesn’t fall off.
In windy conditions you may need assistance of
a second person, or park so that the wind is
blowing across the roof from the passenger
side.
Step 4.
Raise the roof
12” or so at the front so that there
is a small opening at the rear. Pull the cover
gently down so that the front two corners of the
roof are inside the front two corners of the
cover.
It is important to get this right to ensure correct
fit of your cover. Once the front two corners are
in place, pull the rear corners of the cover over
the rear corners of your roof.
Step 5.
Once all four corners are correctly in place,
continue raising the roof as per your
manufacturer instructions. When the roof is fully
raised, the cover will fit nicely along the
passenger side and the driver’s side should be
hanging down with the 5 buckle fasteners.
Step 6. (no fixed awning)
If your vehicle is not fitted with a fixed roll out
awning, simply undo the 5 clips, slide them
along the awning rail, clip them all into place
and gently tighten the adjustable straps so that
the cover first neatly all the way along. Do not
over tighten as you do not want to exert
excessive pressure on the roof.
