background image

UTV-DRS-K

WARRANTY

WARRANTY

KFI Products

1 YEAR LIMITED WARRANTY

Warranty Qualifications

Kappers Fabricating, Inc. (KFI) will warranty with 

a  copy of your sales receipt from one of KFI’s retail 

locations as proof of purchase. 

Repair/Replacement 

Warranty

Kappers Fabricating, Inc. (KFI) warrants to the 

original purchaser that the mechanical and 

electrical components will be free from defects 

in materials and workmanship for a period of one 

(1) year from the original date of purchase. We will 

repair or replace, at our discretion, parts found 

to be defective due to materials or workmanship. 

This warranty applies only to products which have 

been properly assembled, adjusted, and operated 

in accordance with the instructions contained 

within the product manual. This warranty does not 

apply to any product of Kappers Fabricating, Inc. 

that has been subject to alteration, misuse, abuse, 

improper assembly or installation, or shipping 

damage.

Do Not Return The Unit 

To The Place Of Purchase

In the event you have a claim under this warranty, 

contact KFI’s Technical Service and KFI will 

troubleshoot any issue via phone or e-mail. If 

the problem is not corrected by this method, KFI 

will, at its option, authorize evaluation, repair or 

replacement of the defective part or component 

at a KFI Service Center. KFI will provide you with 

a case number for warranty service. Please keep 

it for future reference. Repairs or replacements 

without prior authorization, or at an unauthorized 

repair facility, will not be covered by this warranty.

Warranty Exclusions

This warranty does not cover the following repairs 

and equipment:

Normal Wear

This product needs periodic parts and service to 

perform well. This warranty does not cover repair 

when normal use has exhausted the life of a part 

or the equipment as a whole.

Other Exclusions

This warranty excludes: Cosmetic defects such 

as paint, decals, etc. Failures due to acts of God 

and other force majeure events beyond the 

manufacturer’s control. Problems cause by parts 

that are not original KFI Products parts.  Failures 

due to Water intrusion.

limits of Implied Warranty 

and Consequential Damage

THIS WARRANTY DOES NOT APPLY TO ANY 

INCIDENTAL OR CONSEQUENTIAL DAMAGES 

AND ANY IMPLIED WARRANTIES ARE LIMITED TO 

THE SAME TIME PERIODS STATED HEREIN FOR ALL 

EXPRESSED WARRANTIES.

THE WARRANTY SET FORTH ABOVE IS THE ONLY 

WARRANTY. THERE ARE NO OTHER WARRANTIES, 

EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED 

TO IMPLIED WARRANTIES OF MERCHANTABILITY OR 

FITNESS FOR A PARTICULAR PURPOSE.

Some states do not allow the exclusion of implied 

warranties or the exclusion or limitation of liability 

for incidental or consequential damages, or 

limitations on how long an implied warranty lasts, 

so the above limitation or exclusion may not apply 

to you. This warranty gives you specific legal rights. 

You may also have other rights that vary from state 

to state.

Contact Information

Address

KFI Products

Customer Service

721 Sata Drive 

Spring Valley, MN 55975

www.kfiproducts.com

Technical Service

Mon – Thu, 8:00 AM – 5:00 PM (CST)

Fri, 8:00 AM -  1:00 PM (CST)

Toll Free: 1-877-346-2050

[email protected]

Содержание UTV-DRS-K









Отзывы: