KFI SE25, Руководство пользователя, Страница: 15 / 24

13
MODEL #SE25 – 2,500LB (1134KG) WINCH OPERATION
Synthetic Cable Inspection
Periodically, inspect the synthetic cable for wear. When
new, it will have a smooth finish (see Figure A).
(A) New Cable
After normal use, the outer surface will appear slightly
fuzzy (see Figure B). This is expected and protects the
underlaying fibers.
(B) Slight Fuzz
(C) 25% Frayed
Once approximately 25% of the outer fibers show wear
(see Figure C), the cable must be replaced.
Inspect the inner and outer fibers by compressing the
cable (see Figure D).
maInTenanCe
The owner/operator is responsible for all periodic
maintenance.
Complete all scheduled maintenance in a timely manner.
Correct any issue before operating the winch.
Motor
Periodically when not used very often, or after wet / damp
conditions. Be sure to run the motor in free spool until
the motor is warm. This helps dry out any moisture and
condensation trapped inside the housing.
Lubrication
All moving parts within the Electric Winch have been
Lubricated using high temperature lithium grease at the
factory. No internal lubrication is required under normal
conditions.
If the winch is subjected to extreme conditions lubrication
may be required using a high temperature lithium grease.
Retract Cable Assembly onto drum being careful not to
allow kinking or over heating of the winch.
WarnInG
Never operate a damaged or
defective winch.
WarnInG
Improper maintenance will void
your warranty.
noTICe
For service or parts assistance,
contact our help line at
1-877-346-2050.
noTICe
Do NOT attempt to lubricate or
grease the synthetic cable. Grease and oil will
attract dirt and debris which cause abrasion.