2
Switch Location
Plug Location
“Figure 6”
8.
Connect your Motor Wires to the winch
and reassemble the bumper to the frame by
re-fastening the hardware that was
removed in step 3, 4, and 5.
9.
Using the instructions provided with your
winch, wire accordingly.
10.
Once all wiring is complete re-assemble
items from steps 1 and 2.
Note: Large grill
(B) will not be replaced, but can be replaced with
optional replacement grill sold separately.
EXTRA HELPFUL INFORMATION
Note: Some machines may vary from pictures shown due to
changes in the different series of Rangers. Pictures that are
shown are of a 2006 Ranger 700 EFI
1.
For optional contactor location please see “Figure 5”
2.
Mini-Rocker Switch Hardware kit. This allows you to
mount your usual handle bar mounted switch to almost
any desired location.
a.
Remove handlebar mount hardware from the
switch.
b.
Locate desired mounting location
c.
Mark and drill two switch holes through dash
using switch housing as a template
d.
Drill a 3
rd
hole for the switch wiring.
e.
Assemble per Figure 7
3.
If your kit has a corded switch “Figure 6” shows the location
for mounting the plug-in receptacle. It is pre-marked in the
plastic.
4.
Ignition Wire
a.
Connect the red wire from the remote or switch to
the red/white wire from the back of the ignition
switch using an in-line wire clip (not included)
Contactor Location
“Figure 5”
STANDARD
LH 2-HOLE
WIDE BOLT PATTERN
RH 2-HOLE
“Figure 4”
“Figure 7” Mini-Rocker Mounting
