Keysight U8903B, Руководство пользователя

Страница: 143 / 605

Audio Generator Functions 3
Keysight U8903B User’s Guide 143
Output Configuration (Digital Generator)
The output configuration for the digital generator is displayed as shown in Figure 3-57 .
Figure 3-57 Digital Generator > Output Config menu page 1
Table 3-29 Digital Generator > Output Config menu description
Menu Description
Connector
Press the Connector softkey to select the output connector type.
– Bal
Balanced mode outputs a digital signal on the XLR output connector at the U8903B rear panel.
– UnBal
Unbalanced mode outputs a digital signal on the BNC output connector at the U8903B rear panel.
AES Output Press the AES Output softkey to enable or disable the AES output.
Optical Output Press the Optical Output softkey to enable or disable the optical output.
Sample Rate Press the Sample Rate softkey to set the sample rate value.
Audio Format
Press the Audio Format softkey to select the encoding audio format.
– Linear PCM
– A-Law
–
μ -Law
Dither
Press the Dither softkey to select the dither type. Dither is a noise component that can be superimposed on a signal.
– Off
– Rectangular
– Triangular
– Shaped
Ref Clock
Press the Ref Clock softkey to configure the reference clock settings. Refer to “ Reference clock ” on page 144 for more
information.
Sync Clock
Press the Sync Clock softkey to configure the sync clock settings. Refer to “ Sync clock ” on page 145 for more
information.