Keysight U1176A LED Flashlight
Operating Instructions
This LED flashlight is designed for used with Keysight handheld digital multimeters. The LED
flashlight helps make measurements easier while using handheld digital multimeters in dark
places.
Assistance
For technical assistance, contact your nearest Keysight Sales Office or visit the Keysight web-
site at
for further information.
Product Characteristics
OPERATING ENVIRONMENT: Operating temperature from –10 °C to 55 °C.
STORAGE ENVIRONMENT: Storage temperature from –20 °C to 60 °C.
RELATIVE HUMIDITY (R.H.): Relative humidity up to 80% for temperature up to 30 °C, decreas-
ing linearly to 50% R.H. at 55 °C.
POWER CONSUMPTION: 90 mVA for single 1.5 V AAA battery
BATTERY TYPE: Alkaline 24 A (ANSI/NEDA) and LR03 (IEC), or Zinc Chloride 24 D (ANSI/NEDA)
and
R03 (IEC).
DIMENSION (W × L × H): 16.3 mm × 80.0 mm × 33.5 mm
WEIGHT: 25 g with battery
ELECTROMAGNETIC COMPATIBILITY (EMC): Susceptibility and emissions: Commercial limits
per EN61326-1, Pollution Degree II Environment and altitude up to 2000 m.
•
When using the LED flashlight for the first time, remove the
insulating material situated between the anode of the battery and
the circuit.
•
Do not open the plastic case unnecessarily. Doing so may cause
damage to the plastic case plastic case.
•
Keep the LED flashlight away from getting wet.
•
Ensure the LED flashlight is turned OFF and the battery cover
removed when replacing the battery.
•
Remove the battery when not using the LED flashlight for a long
time.
•
If the LED flashlight is not lighted when turned on, replace with a
specified battery.
•
You are advised to use low leakage batteries when changing to new
batteries.
•
The battery must be recycled or disposed properly after depletion.
•
The LED flashlight can only be used with handheld digital
multimeters or test leads from Keysight.
2. Attach the clip of the flashlight on the hand guard of test lead.
If any portion of the LED flashlight is worn out or damaged, replace with a new LED flashlight.
Maintenance
This information is subject to
change without notice.
© Keysight Technologies 2010-2017
Edition 4, September 2, 2017
Printed in Malaysia
U1176-90001
1. Mount the clip of the LED flashlight on a test lead.
Mounting on test lead
