2
Determining the Installed Version
Firmware version contents are displayed by the Soft Front Panel (SFP)
Help About screen of the PXIe Chassis Family driver. However, you can
only see the Trigger Bridge firmware version when using PXIe Chassis
Driver 1.7.82.1 or later. You cannot observe the Trigger Bridge firmware
version using the PXIe Chassis Family driver prior to 1.7.82.1. Please
download and install the latest driver from
www.Keysight.com
. Search
on your chassis model number. Click on “Visit Technical Support” and
then click on the tab for “Drivers, Firmware & Software”. After installing
version 1.7.82.1 or later, run the SFP for your chassis and click on
Help>About. Refer to the next page of this document to identify which
firmware version is installed.
The figure below shows an example of the Help>About for an M9019A
chassis. In this example, the version of the Trigger Bridge version
number matches that of the 2018 firmware. If the 2017 firmware were
installed, it would show version 0 for the Trigger Bridge.
Figure 1. M9019A SFP Help About
PXIe Chassis Firmware Guide
9
