Keysight M9217A PXIe 2-CH, Руководство для стартапов

Страница: 23 / 36

23 Keysight M9217A Startup Guide
Figure 3
Installing the module to the chassis
5 Hold the module by the injector/ejector handle, and slide it into an available PXIe (or
hybrid) slot, as shown in
Figure 3 .
– Install the module into the PXIe slot of the chassis by placing the module card
edges into the front module guides (top and bottom).
– Slide the module to the rear of the chassis and assure that the injector/ejector
handle is pushed down in the unlatched (downward) position.
– Slide the module completely into the chassis.
– When you begin to feel resistance, push up on the injector/ejector handle to fully
inject the module into the chassis.
6 If you are using a remote controller, install the System Interface Card in the chassis.
7 Latch the module by pulling up on the injector/ejector handle and secure the front
panel to the chassis using the module front-panel mounting screws.
8 Tighten the screws on the module (or remote controller) front panel. Performance may
suffer if the screws are not tightened properly.
9 Verify that the PXIe chassis fans are operable and free of dust and other contaminants
that may restrict airflow.
10 Install all chassis covers and filler panels after installing the module. Missing filler
panels may disrupt necessary air circulation in the chassis.
11 If you are using a remote controller, connect the System Interface Card in the chassis to
host computer.