Keysight M9187A, Руководство для стартапов

Страница: 28 / 32

28 Keysight M9187A PXI Digital IO Startup Guide
M9187A Module Accessories
Disassembling the Connector Block Clam Shells
1 Loosen the two screws indicated in Figure 6. These screws are captive to the
bottom half of the clam shell. Note: the other two screws are for the strain
relief.
2 Separate the two clam shell halves. Be careful not to lose the long screw locks
used to secure the terminal block to the module.
3 To use the strain relief, loosen the two strain relief screws and lift up on the
strain relief bar. Refer to Figure 7.
4 Insert your cable under the strain relief bar and retighten the two strain relief
screws.
5 To reassemble the clamshell, make certain the screw locks are in place. Place
the calm shell halves together. Tighten the two clam shell screws.
Figure 6 Disassembling the Terminal Block Clam Shell
Figure 7 Using the Strain Relief Clamp
Screws for
Strain Relief
Loosen these
two captive
screws to
separate clam
shell halves
Wires go under
strain relief bar.
Do not over tighten
strain relief clamp.
Do not over tighten the strain relief screws. Possible damage to
the cable(s) may occur if overtightened. Use only sufficient
tension to secure the cable in place.