Keysight DCA-X Series, Быстрый старт

Страница: 20 / 48

2 Installing the N1000A
Step 2. Work at a Static-Safe Workstation
Electrostatic discharge (ESD) can damage or destroy electronic components.
All work on instruments and electronic components should be performed at a
static-safe workstation as shown in
Figure 6 . The static-safe workstation uses
two types of ESD protection:
n
Conductive table-mat and wrist-strap combination.
n
Conductive floor-mat and heel-strap combination.
Figure 6. Example of Static-Safe Workstation
The following suggestions may reduce ESD damage that occurs during testing
and servicing operations.
n
Personnel should be grounded with a resistor-isolated wrist strap.
n
Be sure all instruments are properly earth-grounded to prevent a buildup of
static charge.
These techniques for a static-safe workstation should not be used when
working on circuitry with a voltage potential greater than 500 volts.
20 N1000A Quick Start Guide