Programming
3
Keysight 53147A/148A/149A Operating and Programming Guide
207
Command Reference
This section describes the SCPI Subsystem commands and the IEEE 488.2
Common Commands for the Keysight 53147A, 53148A, and 53149A. The
information in this section is intended to help you program the instrument over its
GPIB or RS-232 serial interface.
The commands are presented in alphabetical order.
– SCPI Subsystem commands are described on pages 208
through 251.
– IEEE 488.2 Common command descriptions start on page 253.
– A description of the Group Execute Trigger command is also included on
For each command description:
– Where the phrase “Sets or queries” is used, the command setting can be
queried by omitting the parameter and appending a “
?
” to the last command
keyword.
– For example,
:ROSC:SOUR INT | EXT
can be queried with
:ROSC:SOUR?
– Unless otherwise noted, a command described as an
event
cannot be queried.
– Unless otherwise noted, the command setting is affected by
*SAV/*RCL
.
– The square brackets, [ ], are used to indicate that the element(s) within the
brackets are optional. Note, the brackets are
not
part
of the command and should not be sent to the instrument.
– The vertical bar, |, is used to mean “OR” and is used to separate alternative
options.
– The short form of keywords is shown in uppercase.
– Quotation marks may be part of the command's parameter;
the quotation marks shown must be sent to the instrument.
– Unless otherwise noted, a command is sequential (not overlapped).
Содержание 53147A
Страница 1: ...Keysight 53147A 148A 149A Microwave Frequency Counter Power Meter DVM Operating and Programming Guide ...
Страница 20: ...20 Keysight 53147A 148A 149A Operating and Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...
Страница 310: ...312 Keysight 53147A 148A 149A Operating and Programming Guide THIS PAGE HAS BEEN INTENTIONALLY LEFT BLANK ...