Keysight Technologies U3022AH10, Руководство пользователя и сервисное руководство

Страница: 25 / 92

U3022AH10 System Configurations
Each end of the interconnect RF cables have a different length from the bend.
When connecting the RF Interconnect cables ensure that the longer end from the
bend is connected to the PNA-X.
Over - torque will cause damage to the Test Set and may cause connectors to
spin or become loose.
4. Add the front panel port labels to the N5242A /B Option 400 (4-Port). Refer to Figure 1 2 on page 2 6 .
•
Port 13 over Port 3 (U3022-80002)
•
Port 14 over Port 4 (U3022-80003)
5. Connect the cable (N4011-21002) from the PNA-X Test Set I/O to the U3022AH10 Test Set I/O on
the rear panel. See Figure 1 3 on page 2 6 .
6. The 2-digit numbers in Figure 12 on page 2 6 refer to the corresponding cable number (last two
digits) listed in Table 8 . Install the eight semi-rigid cables in the recommended sequence (please
note that it might be necessary to reform the semi-rigid cable slightly to fit in place). Tighten to 8
in-lbs torque.
Table 8 PNA-X to Test Set RF Cable Interface Connections
Numeric
Order RF Cables From (PNA-X) To (Test Set)
1 U3022-20092 Port 1, CPLR ARM CPLR ARM
2 U3022-20094 Port 1, SOURCE OUT SOURCE OUT
3 U3022-20091 Port 1, RCVR A IN A IN
4 U3022-20093 Port 1, CPLR THRU CPLR THRU
8 U3022-20093 Port 2 CPLR THRU CPLR THRU
7 U3022-20091 Port 2, RCVR B IN B IN
6 U3022-20094 Port 2, SOURCE OUT SOURCE OUT
5 U3022-20092 Port 2, CPLR ARM CPLR ARM
1. Remove the four front panel jumpers on the PNA-X (Ports 1 & 2) from the SOURCE and RCVR
ports. The Reference jumpers must remain installed.
2. If not already installed, connect the 16 front panel jumpers (N5222-20091), as shown in
Figure 12 on page 2 6 .
3. Connect the RF cables from the N5242A /B Network Analyzer to the Test Set. Torque each
cable to 8 in-lb. Refer to Table 8 on page 2 5 , Figure 1 2 and Figure 1 3 on page 2 6 .
System Setup, 12/14 Port RF Cable Interface Configuration
Figure 1 2 and Figure 1 3 on page 2 6 illustrate the interface cable configuration of the U3022AH10
Multiport Test Set and how it should be configured to the N5242A /B Option 200 (2-Port) or 400
(4-Port) PNA-X Network Analyzer.
U3022AH10 User's and Service Guide 25