Keysight Technologies PD1000A, Руководство по эксплуатации

Страница: 14 / 44

14 Keysight PD1000A Test Fixture Operating Guide
General Test Setup
Connecting the Bias T Networks to a Keysight B2902A SMU
Figure 4 below shows how to connect two PD1000A Bias T Networks to the
B2902A Source Measure Unit (SMU). Channel 1 on the SMU (front panel)
connects to the PD1000A Bias T for the RF input (Gate) to the device under test
(DUT). Channel 2 on the SMU (rear panel) connects to the PD1000A Bias T for
the RF output (drain or collector) of the DUT.
Figure 4 PD1000A Bias T Networks used with the B2902A SMU
B2902A CH2 Rear Panel to
PD1000A Drain/Collector Bias T
B2902A CH1 Front Panel to
PD1000A Gate Bias T
PD1000A
Bias T for the Gate
PD1000A Bias T
for Drain
PD1000A Test Fixture
for TO-247 Devices
SMA to Port 1 of
Network Analyzer
SMA to Port 2 of
Network Analyzer