Keysight Technologies N6705C, Руководство по эксплуатации и обслуживанию

Страница: 372 / 476

Test Equipment and Setups
Equipment Required
Measurement Setups
Equipment Required
The test equipment recommended for the verification and calibration procedures is listed below. If the
exact instrument is not available, substitute calibration standards of equivalent accuracy.
Instrument Requirements Recommended Model Use1
Digital Multimeter Resolution: 10 nV @ 1V
Readout: 8 1/2 digits
Accuracy: 20 ppm Keysight 3458A or equivalent V, C
Current Shunt2 15 A (0.1 Ω )
30 A (0.1 Ω )
50 A (0.05 Ω )
Guildline 9230A-15R
Guildline 9230A-30
Guildline 9230A-50 V, C
Load Resistors 25 Ω , 250 W, 1% (N6751A/52A/61A/62A)
4 Ω , 250 W, 1% (N6751A/52A/61A/62A)
20 k Ω , 1%, 1/8W (for option 1UA/2UA)
10 Ω , 1%, 1/8W (N678xA SMU)
10 k Ω , 1%, 1/8W (N678xA SMU)
1 M Ω , 1%, 1/8W (N678xA SMU)
Vishay NH-250-25 Ω -1%
Vishay NH-250-4 Ω -1%
C
C
V, C
V, C
V, C
V, C
Electronic load2 150 V, 50 A minimum, with transient capability and a slew
rate of 833 kA/s or better Keysight N3300A mainframe, with
N330xA modules V, C
Keysight N6784A Load for N678xA SMU and N6783A (set to CC load mode) Keysight N6784A V
GPIB controller Full GPIB capabilities Keysight 82350B or equivalent V, C
Oscilloscope Sensitivity: 1 mV
Bandwidth Limit: 20 MHz
Probe: 1:1 with RF tip Keysight DSO6054A or equivalent V
RMS Voltmeter True RMS
Bandwidth: 20 MHz
Sensitivity: 100 µV Rhode and Schwartz Model URE3
or equivalent V
Differential Amplifier Bandwidth: 20 MHz LeCroy DA1855A, DA1850A, or
equivalent V
Terminations 1 – 50 Ω BNC termination
2 – 50 Ω 1/8 W termination resistors
V
Variable voltage transformer
or AC source Adjustable to highest rated input voltage
Power: 500 VA Keysight 6813B or equivalent V
RC – for N678xA transient
test Capacitor: 150 μF fixed film
Resistor 50 m
Ω
EPCOS B32526R0157K
Vishay LVR01R0500FE70 V
1 V = Verification C = Calibration
2 Dependent on rating of model being tested
8 Verification and Calibration
372 Keysight N6705C Operating and Service Guide