Installation Note N5245-90012 7
Getting Prepared
Tools Required for the Installation
About Installing the Upgrade
Description
Qty
Part Number
T-6 TORX driver - set to 4 in-lbs (0.45 N.m)
1
N/A
T-10 TORX driver - set to 9 in-lbs (1.02 N.m)
1
N/A
T-20 TORX driver - set to 21 in-lbs (2.38 N.m)
1
N/A
5/16-in (8 mm) nutsetter or open end torque wrench - set to
10 in-lbs (1.13 N.m)
1
N/A
5/16-in (8 mm) nutsetter or open end torque wrench - set to
21 in-lbs (2.38 N.m)
1
N/A
3/16-in (5 mm) nutsetter or open end torque wrench - set to 6
in-lbs (0.68 N.m)
1
N/A
5/8-in (16 mm) nutsetter or open end torque wrench - set to
21 in-lbs (2.38 N.m)
1
N/A
9 mm nutsetter or open end torque wrench - set to 21 in-lbs
(2.38 N.m)
1
N/A
1-in (25.4 mm) torque wrench - set to 72 in-lbs (8.15 N.m)
1
N/A
1/4-in (6 mm) open end wrench
1
N/A
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the front and rear panel cable connectors. On these, use a 9 mm
nutsetter or open end torque wrench set to 21 in-lb.
Products affected
N5244A and N5245A Option 219
Installation to be performed by
Keysight service center or personnel qualified by Keysight
Estimated installation time
5 hours
Estimated adjustment time
0.5 hours
Estimated full instrument calibration time
4.5 hours
