4
i7090 System Installation
Safety Notices
Safety Notices
The following general safety instructions must be followed when using,
maintaining, and repairing this equipment. If these instructions are not strictly
followed, the user may be exposed to hazards, or equipment damage may occur.
Keysight Technologies assumes no liability for injury or damage if these instructions
are not followed.
Installation
Before you turn on the power, verify that the AC mains supply voltage
matches the voltage marked on the system specifications plate on the back
of the equipment.
This equipment must be connected to a properly installed earth ground. Do
not operate the equipment until it has been properly earthed by a qualified
electrician.
Overcurrent protection must be provided for this equipment. See the
installation instructions for overcurrent recommendations. Do not operate
the equipment until proper overcurrent protection has been installed by a
qualified electrician.
This equipment is not intended for use near explosive or corrosive hazards.
Operation
Printed circuit board assemblies (PCBAs) may be electrically charged
during the normal test cycle. Do not touch any parts which may be
electrically charged.
Do not remove covers or parts of the equipment enclosure. There are no
operator-serviceable parts inside.
Do not operate damaged equipment.
Servicing
All fuses must be replaced only with fuses of the specified type. Do not
modify the equipment or use unapproved replacement parts.
