Keysight Technologies B1542A Pulsed IV Package, Руководство пользователя

Страница: 46 / 160

3-6 Keysight B1542A User’s Guide, Edition 10
Performing System Setup and Compensation
Starting System Setup
Starting System Setup
Perform the following procedures. If you use the DSO/MSO 9000 series or S series
oscilloscope, also perform the procedure described in
“If You Use DSO/MSO 9000
Series or S Series Oscilloscope” on page 3-7 .
NOTE If you use an external computer as the system controller, skip the following
procedures and perform the procedures described in
“If You Use External
Computer” on page 3-8 .
1. Connect GPIB cable between the B1500A and the system instruments if it is still
not connected.
2. Connect BNC cable between the pulse generator TRIGGER OUT connector and
the oscilloscope AUX Trig In connector if it is still not connected.
3. Turn on the system instruments.
On the Keysight
Connection Expert
1. If the B1500A displays the Start EasyEXPERT window, close it first.
2. Launch Keysight Connection Expert (see Figure 3-1 ).
3. Check the GPIB configuration. The System Controller must be set to Yes.
4. Check the VISA interface ID. It must be
GPIB0
.
5. Close Keysight Connection Expert.
On the
EasyEXPERT
1. Launch EasyEXPERT.
2. Click the Start EasyEXPERT button.
3. Open your workspace or create a new workspace.
4. Display the Application Test tab screen.
5. Open the PLSDIV Setup test definition.
6. Set the DcSwitch field to Yes. Do not set No.
7. Save the test setup to your preset group (My Favorite Setup).