Keysight Technologies 85058V, Руководство пользователя и сервисное руководство

Страница: 35 / 58

85058V 3-15
Use, Maintenance, and Care of the Devices
Handling and Storage
CAUTION You don’t have to fully break the handle of the torque wrench to reach the
specified torque; doing so can cause the handle to kick back and loosen the
connection. Any give at all in the handle is sufficient torque.
4. Tighten the connection just to the torque wrench break point. The wrench handle gives way
at its internal pivot point. See Figure 3-8 . Do not tighten the connection further.
How to Separate a Connection
NOTE Do not turn the device body. Only turn the connector nut. Damage to the center
conductor can occur if the device body is rotated.
1. Use an open-end wrench to prevent the device body from turning.
2. Use another open-end wrench to loosen the connector nut.
3. Complete the disconnection by hand, turning only the connector nut.
4. Pull the connectors straight apart without twisting, rocking, or bending either of the
connectors.
Handling and Storage
• Do install the protective end caps and store the devices in the foam-lined storage case when
not in use.
• Do keep connectors and beaded lines clean.
• Do not store connectors and beaded lines loose in a box, or in a desk or bench drawer. This
is the most common cause of connector damage during storage.
• Do not touch mating plane surfaces. Natural skin oils and microscopic particles of dirt are
easily transferred to a connector interface and are very difficult to remove.
• Do not set connectors contact-end down on a hard surface. The plating and the mating
plane surfaces can be damaged if the interface comes in contact with any hard surface.