KEYKING GROUP 6630KE Keypads Reader Operation Manual (1.00)
Page 8
Keyking Group Limited
33 Jabotinski St., Twin Tower 1, Ramat Gan, 52511,Israel
website: www.keyking.net E-mail: [email protected]
Chapter 4: Installation
Installation Procedure:
4.1
Install on the wall (Based on Internal Back Box)
1.
Install a Reader Back Box inside wall:
Determine an appropriate
mounting position
for the
reader. Install a single or double standard electrical box (86*86mm) inside wall. If mounting to a
metal surface, drill two 7/64 (.109) inch holes and use the enclosed self tapping screws for
mounting.
a). Reader Back Box (Standard Electronic Box, single) b). Reader Back Box (Double)
2.
Route:
Route the interface cable from the reader to the Host.
3.
Wiring:
Install all wires to the green connector according below image.
4.
Plug the Green Connector:
Plug the green connector to the reader socket.
5.
Set the JUMPER (Output mode):
select W26 or W34 bits output of reader
.
6.
Mount the reader body:
Mount the reader body to the Electronic Box (Reader Back Box) using the
two screws. Two #6-32 x 1 inch screws are provided for mounting to a gang box or metal surface.
7.
Put the top cover
and face plate.
