3. Unscrew the small knob that holds the numbered
metal plate in position. Now remove the plate from the
facia.
4. Again note the arrows displayed on the slotted disks.
Using the screwdriver return any of the disks used in the
original code to their upright and neutral position.
5. Now carefully repeat all of the steps in the sections
marked ‘Setting your own code’ and ‘Checking your
code’.
FITTING YOUR KEYGUARD.
To fit your Keyguard you will need the following tools:
1 x Power Drill
1 x 5mm Masonry Drill Bit
1 x Cross Headed Screwdriver
1 x Lightweight Hammer
1 x Black Permanent Marker
1. The diagram below shows an internal view of the rear
wall of your Keyguard. Three appropriate fixing screws
have been supplied with your Keyguard and it is
recommended that you use the three fixing points
highlighted on the diagram.
2. Locate a sound piece of masonry or brickwork in the
area where you wish to fix your Keyguard. It is
suggested that you choose a site that is accessible yet
one that is not too prominent. Remove the facia from
the Keyguard, position the body firmly against the wall
and hold in place. Use the pen to make marks on the
wall through the highlighted fixing holes.
3. Attach the 5mm bit to the power drill. Carefully drill a
hole at each of the marked fixing points; each hole
should be 50mm deep.
4. Position the Keyguard so that the fixing holes are
aligned with the drilled cavities. By hand push the first
screw and rawl cover into position. Repeat this with the
two remaining fixings.
5. Locate the cross head of your screwdriver into the
cross on your first fixing. Using the hammer gently tap
the screw and rawl cover into the drilled cavity so that
the rawl cover is fully inside the wall. Repeat this step
with the two remaining screws.
6. Finally use the screwdriver to fully tighten all three
fixing into position. You should find your Keyguard is
firmly secured in position.
LIMITED WARRANTY.
Keyguard Security Ltd, Brockholes, Holmfirth, HD9 7BN,
Tel: 01484 663388, (“Keyguard”) warrants the original
buyer of its products for a period of 1 year after the date
of purchase that the products are free from defects in
workmanship and materials. This warranty does not
cover forgotten or incorrectly set combinations.
Keyguard will, without charge to the buyer, repair or
replace, at its option, any defective product returned by
the original buyer to Keyguard at the business address
above within 1 year of purchase. The foregoing
warranty does not cover damage caused by abuse or
misuse. Keyguard does not warrant that this product
cannot be broken into.
I
N NO EVENT WILL
K
EYGUARD BE LIABLE FOR LOSS OF USE
,
LOST PROFITS
,
THEFT
,
PROPERTY DAMAGE
,
OR SPECIAL
,
INCIDENTAL
,
OR CONSEQUENTIAL
,
DAMAGES OF ANY SORT
.
In the event of product malfuntion please contact
Keyguard Security Ltd on 01484 663388.
Operating and Fixing
Instructions
Insight Medical Products Limited
advocate safe working practices.
Please take care when using power
tools to fix this product into position.
