14
4. Carbon brush
It is very difficult for customers to repair the tool
for themselves. Contact nearby A/S center
(agencies) for solution.
3. Screws
Make sure screws in each part are set tightly at
regular intervals. When screws are loose, fasten
them tightly. The loose screw causes the danger
situation.
2. Change of the grinding stone
Please change the grinding stone with new one
when outer diameter of the grinding stone in 100
mm is worn to 50 mm (For the grinding stone in
115 mm is 60 mm)
12. Residual current device
(Only for Australia and Newzealand markets)
Recommendation that the tool always be
supplied via residual current device with a rated
residual current of 30 mA or less.
1. Cleaning
For safe and proper working, always keep the
machine and ventilation slots clean.
Before any work on the machine itself
(maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool.
13. Dust Cover Cleaning
(DG18BL-100S, 115S, 125S)
ƃ
Disassemble the dust cover in accordance with
the following photo.
ƃ
Clean the dust cover with an air blower and
reassemble the parts.
If you use the product without the dust
cover intact, it may cause problems with its
durability. Please make sure the dust cover
is properly installed.
※ Keeping the dust cover clean ensures
high durability of the product.
̻
Maintenance and Servicing
ƃ
ƃ
11. How to rotate the head of the
disc grinder
Remove the plug from plug socket before any
operation. For the above purpose, rotate the
head of the disc grinder in a 90-degree turn
instead of rotating the handle. And then, unscrew
four screws and the head. Do not remove the
head from the main body wholly but rotate to new
position. After that, set four screws and fasten
them.
15
8. Y attachment cord
If the replacement of the supply cord is
necessary. this has to be done by the
manufacturer or his agent in order to avoid a
safety hazard.
9. After-sales Service and
Customer Assistance
Our after-sales service responds to your
questions concerning maintenance and repair
of your product as well as spare parts.
Exploded views and informationon spare parts
can also be found under :
www.keyang.co.kr
Our customer service representatives can
answer your questions concerning possible
applications andadjustment of products and
accessories.
Europe
KEM Europe BV
Hoogstraat 9, 5469 EL Erp, Netherland
Tel:+31-413-288-345
6. Keep after operation
You must keep the tool out of reach of children in
dry place.
7. Abnormal operation
It is very dangerous for customers to
troubleshoot or repair the tool for themselves.
Contact nearby A/S center (agencies) for
solution.
5. Motor
The winding and commutator in the motor are
the core of the disc grinder.
Do not scratch the surface of the winding and
commutator in the motor, and do not apply oil or
water on it.
Dust in the motor causes the trouble of the
motor. After using the disc grinder for 50hours,
let the compressed air in the ventilation slots in
the handle side by rotating the disc grinder in
no-load revolution to eliminate dust from the
motor.
