Raw Water System Troubleshooting
Baitwell and/or Raw Water Pumps Run, but do not pump water
•
Pickup(s) is blocked and is preventing water from reaching the pumps. Put boat in reverse to clear the intake. If
problem persists, do not continue to operate pumps. Clean intake when boat is out of water to remove debris
•
There is air in the raw water washdown system. Prime the system as described on previous page
•
Seacock is not open. Open Valve
•
Raw Water Pump Strainer is clogged. Clean Strainer
Baitwell and/or Raw Water pumps run but water flow is reduced
•
Seacock is not fully open. Open seacock valve fully
•
Debris is partially blocking raw water intake. Clear debris
•
Raw Water Pump Strainer is partially clogged. Clean Strainer
•
Baitwell sprayer head Valve is not fully open. Open Valve fully
•
Raw Water Faucet is not fully open. Open Valve Fully
•
Hose(s) are damaged and are either leaking and or sucking air. Check hoses
•
Low Voltage to Pump(s). Check connections for loose or corroded wiring. Check battery voltage
•
Pump(s) are damaged or defective. Replace Pump(s)
The Raw Water washdown pump continues to run, even after faucet is closed
•
The intake hose going to the pump is damaged and is sucking air. Replace hose
•
Intake hose is loose causing a leak and loss of pressure to the pump. Inspect connections at both the livewell pump
and washdown pump to ensure they are tight.
•
Discharge hose from pump to faucet is loose causing a leak and drop of pressure. Inspect connections and fittings
at both the pump and faucet to ensure they are tight and not damaged. Replace if damaged
•
Strainer is clogged. Clean Strainer
•
Pressure switch on pump is defective. Replace pump or pressure switch
•
Voltage to the pump is low. Check connections for loose or corroded wiring. Check battery voltage
•
Pump is damaged or defective. Replace Pump
