![Key Digital KD-X3x1WUTx Скачать руководство пользователя страница 15](http://html1.mh-extra.com/html/key-digital/kd-x3x1wutx/kd-x3x1wutx_operating-instructions-manual_1960431015.webp)
13
›
Input Select Button
»
Advances through inputs 1, 2, 3 and 4 respectively
»
LED display indicates selected source
»
Press and hold for 5 seconds to active Auto switching . Solid
illumination of the button’s backlighting indicates mode has been set
»
Note: Auto switching is disabled when a manual push button
switching is executed . A fixed auto switching mode may be set
via command string or through KDMS Pro software .
›
IR Sensor
»
Used to collect line-of-sight IR from remote control
»
Receives signals from a 90° angle at up to 30ft away
»
Signal is output on Rx unit / presentation switch’s IR Out port
»
KD-X3x1WUTx is NOT controllable via IR
»
IR and RS-232 supported simultaneously
Rear Connections
›
HDBaseT Output
: Connect a CAT5e/6 cable to the
Rx unit / presentation switch at the port labeled “HDBaseT In”
»
4K/UHD (18G): Up to 100m / 328ft
»
1080p: Up to 150m / 492ft
»
Must connect with KD-UPS52U, KD-X100MRx, or KD-PS42
»
Has been verified some third-party HDBaseT Rx / projectors .
Contact Key Digital Technical Support for more information .
»
Power over HDBaseT from Rx
›
Analog L/R Audio Output:
Connect to audio system .
»
6-pin terminal block with de-embedded audio from the selected source
»
Drives audio signals up to 2 VRMS with a sampling rate of 192KHz
»
Automatically mutes if audio formatting is not PCM 2ch
»
The Pin assignment is as follows:
»
Left + is Pin 1; Left - is Pin 3; Left Ground is Pin 2 .
»
Right + is Pin 4; Right - is Pin 6; Right Ground is Pin 5 .
»
There are no pre-amp or format conversion feature
›
IR In
: Connect to the IR In terminals from a control system or an IR
connecting block .
»
Signal is output on Rx unit / presentation switch’s IR Out port
simultaneously as any IR input collected by the IR Sensor
»
KD-X3x1WUTx is not controllable via IR