6
7
When selecting an EDID from the library, your source device will see the KD-
CATHD300Lite EDID choice instead of the displays EDID, overriding the display’s
EDID information. If your display is not capable of accepting the video resolution or
audio type selected, you may not see a picture or hear sound. In this case please
choose another more compatible EDID, or use the default EDID.
range and resolution:
➔
KD-CATHD300Lite w/ KD-CAT6STP1X Super CAT6 Shielded cabling:
All resolutions up to 1080p, 1920x1200, 3D up to 250 ft.
➔
KD-CATHD300Lite w/ Third-Party CAT6/STP cabling:
All resolutions up to
1080p, 1920x1200, 3D up to 200 ft.
nOTe: use metal shielded rJ45 connectors with soldered
ground wires when terminating the CAT6 STP.
Firmware updates:
The KD-CATHD300Lite Tx and Rx have an “Upgrade Mode”
switch located near the RS-232 port. The 2 position slide
switch is marked
“normal”
and
“Program”.
This switch
should only be used in the
“Program”
position when
updating the unit’s firmware. Be sure the switch is in the
“normal”
mode for standard operation.
Specifications
Technical:
➔
Inputs Tx (Each): 1 HDMI, 1 Serial IR Rx, 1 RS-232,
➔
Outputs Tx (Each): 1 CAT6 STP, 1 Serial IR Tx
➔
Inputs Rx (Each): 1 CAT6 STP, 1 Serial IR Rx
➔
Outputs Rx (Each): 1 HDMI, 1 Serial IR Tx, 1 RS-232
Settings
edid Control
EDID settings may be necessary when connecting to or from an AV Receiver, or for
passing 3D content derived from a Cable or Satellite source. They can also speed up
the switching process from Cable or Satellite.
The possible EDID settings can range from ‘0’ to ‘9’. (‘0’ is the default).
0
EDID from connected display
1
1080i w/ PCM 2ch Digital Audio
2
1080i w/ HD Audio
3
1080p w/ PCM 2ch Digital Audio
4
1080p w/ HD Audio
5
3D w/ PCM 2ch Digital Audio
6
3D w/ Dolby Audio
7
3D w/ HD Audio
8
DVI 1080p
9
DVI 1080p with Forced HPD
The EDID controls are located on the Tx Extender. To change EDID settings, use a
small flat bladed screwdriver to turn the rotary switch to the desired EDID setting.
The switch clicks at each position to ensure the arrow is pointing at a number and
not in-between. There is no need to power the unit off when adjusting the EDID
settings. The unit will automatically renegotiate the new handshake in a few seconds.
Please follow this procedure for subsequent EDID changes.
rotary edid Control Switch
KD-CATHD300Lite_Manual.indd 6-7
6/20/13 11:42 AM
