2
3
kewtechcorp.com
kewtechcorp.com
Operation elements and connectors
1. Measuring terminals N, PE
2. Measuring terminals L1, L2, L3
3. Phase indicator LEDs for L1, L2, L3 terminals
4. PE and CP Signal output terminals
5. PE Pre-Test warning light indicator
6. PE Pre-Test touch pad
7. “E” - CP Error simulation button
8. PP (Proximity Pilot) State rotary switch selector (open, 13A, 20A, 32A and 63A)
9. CP (Control Pilot) State rotary switch selector (A, B, C, D)
10. PE Error (Earth Fault) simulation button
11. Mains socket. Use for test purpose only. Allowed current max. 10 A
12. Mains socket fuse compartment.
Adapter is equipped with 50cm cable with type 2 EVSE connector.
References marked on instrument or in instruction manual.
Warning of a potential danger, read before use and follow the instruction manual
when using this instrument.
Reference! Please use utmost care.
Caution! Dangerous voltage. Danger of electrical shock.
Ground / earth terminal.
Continuous double or reinforced insulation category II IEC 536 / DIN EN 61140.
Conformity symbol, the instrument complies with the valid directives. It complies
with the EMC Directive (2014/30/EU), Standard EN 61326 is fulfilled. It also
complies with the Low Voltage Directive (2014/35/EU) Standards EN 61010-1 and
EN 61010-031.
UK conformity mark.
Instrument fulfils the standard (2012/19/EU) WEEE. This marking indicates that this
product should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of
materialresources. To return your used device, please use the return and collection
systems orcontact the retailer where the product was purchased. They can take this
product forenvironmental safe recycling.
The respective accident prevention regulations established by the professional
associations for electrical systems and equipment must be strictly met at all times.
In order to avoid electrical shock, the valid safety and VDE regulations regarding
excessive contact voltages must receive utmost attention, when working with
voltages exceeding 120V (60V) DC or 50V (25V)rms AC. The values in brackets are
valid for limited ranges (as for example medicine and agriculture).
Measurements in dangerous proximity of electrical systems are only to be carried
out in compliance with the instructions of responsible electronically skilled
technicians, and never alone.
If the operator’s safety is no longer ensured, the instrument is to be put out of
service and protected against use. Safety is no longer ensured, if the instrument:
• shows obvious damage.
• does not carry out the desired measurements.
• has been stored for too long under unfavourable conditions.
• has been subjected to mechanical stress during transport.
The instrument may only be used within the operating ranges as specified in the
technical data section.
1
2
N
PE
L1
L2
L3
PE
PRE-TEST
CP ERROR “E”
PE ERROR
CP STATE
PP STATE
CP
SIGNAL OUTPUT
OPEN
13A 20A 32A
63A
B
KEWEVSE
D
B
A
B
C
TOUCH
PAD
FS T10A/250V, 5x20mm
HP5 1DE
Kewtech Corp. Ltd. Stone’s Courtyard,
Max. 250V~/430V 3~, 50/60HZ, max.10A Load, CAT II 300V
PHASE LED STATUS
4
3
5
6
7
8
9
10
11
12
F
Safety information and explanation of symbols used
