15
14
Storage
Empty the Internal Hot Water Tank and Cold Water Reservoir before storing.
See page 14. Store your brewer in a safe, frost-free environment in an upright
position.
Storing the brewer in cold temperatures may cause any residual
condensation to freeze inside the brewer and could cause damage.
Before using your brewer after storage, wipe the Cold Water Reservoir with a
damp, non-abrasive lint-free cloth and run three (3) cleaning brews (without
K-Cup
®
packs). See page 8 for initial cleansing brew process.
Let brewer rest at room temperature for at least 2 hours before
powering on.
Storing the Power cord
Behind the brewer is a convenient
compartment to hold the Power Cord
during transport or storage (fig. 8).
Service
Beyond these recommended cleaning and maintenance procedures, this
brewer is not user serviceable. See page 18 for warranty guidelines. For
service, please refer to the Warranty section in this guide.
fig.
8
• After 5 seconds, lower Handle and press the BREW button.
• Once solution is dispensed, discard hot contents into sink.
STeP 2: SeConD DeSCALinG SoLUTion RinSe
• Repeat above process up until you press the BREW button.
• When BREW button turns solid red, power off as it starts to dispense.
• Let brewer stand for at least 30 minutes.
• Power on the brewer, lift and lower Handle, then press BREW button.
• Discard the hot contents into sink.
STeP 3: FReSH WATeR RinSe
• Repeat Step 1 (3 times) – using 10 oz. of fresh water each time.
• You may need to perform additional Fresh Water Rinse cycles if you notice
any residual taste.
NOTE:
The cleaning action of Keurig
™
Descaling Solution may result in a foam
dispensed from the brewer. This is natural, as the solution is reacting with the
scale inside. For a brewer that is heavily scaled, the brewer may not fill
properly after the descaler is added. if this occurs, you may see only a small
or no output dispensed followed by the sound of air blowing out. if this occurs:
• Turn off and unplug the brewer.
• Plug the brewer back in, power on, and repeat the Step 3 Fresh Water
Rinse cycle. The brewer should begin to function normally as the solution
is rinsed out and the scale is removed. If problem persists, allow brewer
to sit unplugged for at least 30 minutes before continuing with the rinse.
Visit us online for more information at www.keurig.com/descaling.
P15 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06