GENERAL SAFETY RULES
Warning
When using electric tools basic safety precautions should always be followed to reduce the risk of fi re, electric shock, and personal injury, including the
following:
Read all instructions.
Save these instructions.
For KD-446R and all double insulated tools:
When servicing, use only identical replacement parts.
Guard Against Electric Shock
Prevent body contact with grounded surfaces, for example: pipes, radiators, ranges, refrigerator enclosures.
Keep Children Away
Do not let visitors contact tool or extension cord. All visitors should be kept away from work area.
Store Idle Tools
When not in use, tools should be stored in dry, high or locked-up place out of reach of children.
Don’t Force Tool
It will do the job better and safer at the rate for which it was designed.
Use Right Tool
Don’t force a small tool to do the job of a heavy duty tool. Don’t use tool for on purpose not intended, for example-don’t use a circular saw for cutting tree
limbs or logs.
Dress Properly
Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and footwear are recommended when working out doors.
Wear protective hair covering to contain long hair.
Use Safety Glasses
Use safety equipment. Always wear eye protecion.
Don’t Abuse Cord
Never carry tool by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp edges. Replace damaged cords immediately.
Secure Work
Use clamps or vise to hold work. It’s safer than using your hand and it frees both hands to operate tool.
Don’t Overreach
.
Keep proper footing and balance at all times.
Maintain Tools with Care
Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing center blades and side knives. Inspect tool
cords periodically and if damaged, have repaired by authorized service facility. Inspect extension cords periodically and if damaged or replace. Keep
handles dry, clean, and be free from oil and grease.
Disconnect Tools
When not in use; before servicing; when changing Center Blades, Side Knives, Brushes, etc.
Remove Adjusting keys and Wrenches
Form Habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
Keep Work Area Clean
Cluttered areas and benches invite accidents. Keep work area well lit.
Avoid Dangerous Environment
Don’t expose power tools to rain or snow. Don’t use power tools in damp or wet locations.
SYMBOLS
The symbol on the Caution Label is mean to convey this message. Ne pas exposer a la pluie et ne pas utiliser dans les emplacements humides. Don’t
use power tools in damp or wet locations.
Defi nitions of Symbols
N
o
= No load speed
/min = per minute
Double insulated motor =
Motor
Be sure your power supply agrees with nameplate marking. Use Alternating Current Only (50 to 60 Cycles), 120 volts. Voltage variation of more than
10% will cause loss of power and overheating. Motors are factory tested. If this shear does not operate, check the following: supply line for blown fuses;
plug and receptacle for contact. This tool will stop when the brushes wear to a preset length. Damage to the motor is thus avoided.
