support.kesslercrane.com
Page 10 of 14
USER GUIDE
SETTING UP A MOVE
SECOND SHOOTER PRO
After powering up the system you will be presented with four options:
•
PROGRAM MOVE
•
M ANUAL MOVE
•
TURNTABLE
•
SE T TINGS
SETTINGS
•
Operation Mode – Standalone, Master/Slave, WiFi settings, Quiet Mode settings.
•
Control Options – Inverts Controls depending on user preference.
•
Firmware Update – See “Updating Firmware” section.
•
Lash Compensation
*
– Set up a pre-move to remove any lash in the system due to a
change in direction.
*
Lash Compensation is a unique setting for each pan unit and is set from the factory if the controller and
pan motor are purchased together. If wanting to change these settings, please take note of the factory
setting to be able to reset it. The setting for all other motors should be set to zero.
MANUAL MOVE
Select
M ANUAL MOVE
to do a live move without programming.
The default speed of Manual Move mode is 50%. This selection will be blinking. If you’d like
to adjust that speed up or down you can do so using the Up or Down arrow. Once you’ve
adjusted that to the speed you like, press Enter.
The screen will now display
RUNNING
which allows you to manually move each axis by
using the directional arrows.
The
SE T CALIBRATION
*
feature allows you to focus on the shot rather than worrying
about running your motors into the end of the slider. It works by setting a minimum and
maximum limit range of each axis to avoid collisions and event errors by exceeding the
travel range of each motor.
*Note: When setting your calibration limits, make sure you’ve set your range of every active axis before moving
on to set the second limit range point.
TURNTABLE
Select
TURNTABLE
for continuous panning.
The speed can be adjusted by pressing the Up or Down arrow at any time.
Press the pan Left or Right arrow to start/stop panning.
2.
3.
1.