Kersten FKM 60, Руководство по эксплуатации

Страница: 67 / 76

2018-12-18 67 / 74
Front sweeper FKM 60
Faults / Troubleshooting ENG
8.3 Fault table sweeper
Fault Possible causes Remedy
Hydraulic motor does not
turn
Vehicle does not run. Start carrier vehicle.
Hydraulic power take-off not
switched on.
Switch on hydraulic auxiliary drive.
Hydraulic hoses not connected. Connect hydraulic hoses.
Hydraulic connector not engaged.
If necessary, plug in the hydraulic
connector until it clicks into place.
No hydraulic fluid in the hydraulic
tank.
Top up hydraulic fluid in the hydraulic
tank.
Sweeping roller turns too
slowly
Speed set too low.
Increase the speed at the flow control
valve.
Hydraulic fluid level too low.
Top up hydraulic fluid in the hydraulic
tank.
Leakage on the hydraulic hoses. Replace hydraulic hoses.
Leakage at the hydraulic connectors.
Release hydraulic connector and insert
again until it clicks into place. If leakage
continues, check the hydraulic
connector and replace if necessary.
Leakage at the hydraulic screw
connection.
Slightly loosen the hydraulic screw
connection, move the hose slightly and
tighten the hydraulic screw connection
again.
Contact pressure on the ground too
large.
Align the machine higher so that the
sweeping roller is relieved.
Carburetor adjusted. Adjust carburetor.
Height adjustment stiff
Wheel supports not greased.
Lubricate the wheel supports at the
lubrication points. If necessary.
additionally use creep oil and grease
the threaded spindle.
Sweepings remain lying /
does not sweep clean
Driving speed too high. Reduce driving speed
Broom speed too high / too low. Reduce or increase broom speed.
Sweeping roller height set too high. Adjust the sweeping roller height
according to the specifications.
Collecting container set too high.
Set the collection container to the
correct height.
Side brush set incorrectly. Adjust the side brush properly.