EN
70
ELECTRICAL CONNECTION
WATER INLET HOSE CONNECTION
•
Your Washing Machine requires a 220-240V, 50Hz mains supply.
•
The mains cord of your washing machine is equipped with an
earthed plug. This plug should always be inserted to an earthed
socket of 10 amps.
•
If you do not have a suitable socket and fuse conforming with this,
please ensure the work is carried out by a qualified electrician.
•
We do not take responsibility for damage that occurs due to the use of ungrounded
equipment.
NOTE:
Operating your machine with low voltage will cause the life cycle of your machine to be
reduced and its performance to be restricted.
•
Your machine may have either a single water inlet connection
(cold) or double water inlet connection (hot and cold) depending
on the machine specifications. The white capped hose should
be connected to cold water inlet and red capped hose to the hot
water inlet (if applicable).
•
To prevent water leaks at the joints, either 1 or 2 nuts (depending
on your machine’s specifications) are supplied in the packaging
with the hose. Fit these nuts to the end(s) of the water inlet hose
that connect to the water supply.
•
Connect new water inlet hoses to a ¾ ˝, threaded tap.
•
Connect the white capped end of the water inlet hose to the
white water inlet valve on the rear side of the machine and
the red capped end of the hose to the red water inlet valve
(if applicable).
•
Hand tighten the connections. If in any doubt, consult a qualified
plumber.
•
Water flow with pressure of 0. 1-1 Mpa will allow your machine
to operate at optimum efficiency (pressure of 0. 1 Mpa means
that more than 8 litres of water per minute will flow through
a fully opened tap).
3/4”
10 mm
