EntraGuard
®
Titanium Telephone Entry Controller
Quick Start Guide
Page 11 of 26
P/N: 01962-001 Rev. D
5.0
Communication
The communication section handles three different, but related, topics:
•
Communication between EntraGuard Titanium controller and tenants
•
Communication between the master EntraGuard Titanium controller and the host computer for programming
•
Communication between networked EntraGuard Titanium/PXL-500/510 controllers
NOTE: Keri Systems recommends performing a bench test on each unit prior to installation to rule out any phone line
problems.
5.1
Between EntraGuard Titanium Unit and Tenants
The telephone communication is done via a copper phone line to TB-15. Connect the TIP line to either Pin 1 or Pin 2 then
connect the Ring line to the other Pin (see Figure 12).
Figure 12: TB-15 Phone Line Wiring Connection
There are three ways of connecting the phone line for communication between the EntraGuard Titanium unit and the
tenants.
5.1.1
Single Phone Line for a Single EntraGuard Titanium Unit
For a single EntraGuard Titanium unit, connect the phone line to TB-15 on the EntraGuard Titanium board (see Figure
2 on page 2).
5.1.2
Individual Phone Lines for each EntraGuard Titanium Unit on a Network
The set up for individual phone lines for each EntraGuard unit is the same as for a single phone line for a single
EntraGuard Titanium controller. Each phone line is connected to TB-15 on each EntraGuard Titanium board.
5.1.3
Shared Phone Line for Multiple EntraGuard Titanium Units on a Network
A single phone line may be shared for communication between multiple EntraGuard Titanium units and tenants. The
phone line is plugged into TB-15 on the master EntraGuard Titanium unit with the phone line then going out of the TB-15
phone plug to the next unit’s TB-15 and so on to all the networked EntraGuard units (see Figure 13 on page 12).
NOTE: Sharing a phone line for multiple EntraGuard units is limited to a maximum of 6 units per phone line.
