Kenwood W-38, Инструкция по установке и эксплуатации

Страница: 4 / 12

(2)
Place the third speaker exactly mid-way between the left and right
speakers as shown in Diagram 3.
If the phasing of the central speaker is incorrect, the volume at the
center will fall off and you will notice a deterioration in bass sounds.
To correct this, inter-change the two lead lines of the central speaker.
2. Antenna and Ground Connections (See Diagram 1)
(Antenna for ordinary and shortwave reception)
At a place close to the broadcasting station: A vinyl antenna wire of
about
2.5 meters in length is provided with the set. As shown in
Diagram
4,
peel off the covering at one end and attach the bare wire to
the terminal marked AM.
At a place far from the broadcasting station: Since the radio wave
grows weak if the station is at a distance, the vinyl wire must either be
extended or an antenna set up outside. A special antenna wire is
available but a large vinyl line may be used. Consult your local radio
repair man on how to erect an outdoor antenna.
Inside a ferro-concrete building: Even if you are located close to the
broadcasting station, erect the antenna as far as possible from the wall of
the building.
W-38
ANTENNA TERMINAL
(DIAGRAM 4)
(DIAGRAM 5)
IMPORTANT Do not place the antenna line near fluorescent lighting
which causes disturbance in the form of a buzz.
(Antenna for Listening to a FM Broadcast)
Connect the FM antenna to "G" and "FM" as shown in Diagram 1.
Turn the horizontal part of the T -shaped ant�.nna towards the direction
in which you can receive optimum reception and then pin both ends to
either the ceiling or walls (See Diagram
6., Make sure the antenna
does not sag (Diagram 6) as it will affect the tone quality.
This indoor antenna is inadequate where the electric wave is weak. In
such a case, set up an outside antenna and connect with the "ANT"
terminals marked "G" and "FM". You may use the television antenna
jointly, but if there is a deterioration in the quality of the image erect
separate antennas.
See Diagram
4
for joint connection of television
antenna.
How to Ground
You can keep hum down to a mm1mum when reproducing a record by
grounding the set. As shown in Diagram
7,
drive the earth pole into
ground where there is as much moisture as possible. Solder the end of
a vinyl line to it and connect with the amplifier terminal marked "ANT
G". If the line is left dangling, it will get in the way so stretch if around
4
VINYL
INSULATION
TURN
PULL
COPPER
WIRE
ANTENNA FEED-IN WIRE
AM G FM
TELEVISION
FEEDER
BACK SIDE OF TELEVISION
www.hifiengine.com