Kenwood TS-990S, Инструкция по эксплуатации

Страница: 40 / 290

2 PANEL DESCRIPTION
2-14
Index Contents
SUB-SCREEN
Area Display Description Ref. Page
A
Displays the pass band characteristics of the RX filter.
Rotating the HI/SHIFT or LO/WIDTH control reverses the display numerals (from white on black
to black on white) for 2 seconds.
WIDTH: Appears while in CW, FSK, PSK, or DATA mode.
SHIFT: Appears while in CW, or DATA mode.
LC: Appears while in SSB, FM or AM mode.
HC: Appears while in SSB, FM, or AM mode.
BW: Appears while in SSB, FM, or AM mode.
{page 4-4}
B
Displays the filter width, followed by the low cut or high cut frequency and the shift frequency, as
well as the filter type.
{page 4-4}
Displays the frequency spectra which are fast Fourier transformed (FFT) on the AF stage while
transceiver is in the transmit state.
Displays the center pointer of the notch frequency. Appears while either the Manual Notch Filter
or the Band Elimination Filter is active. Rotating the NOTCH control shifts the center pointer of
the notch frequency to the left or right.
In the center, the pitch frequency is displayed in CW mode - the center frequency is displayed
in all other modes.In CW mode, the frequencies of the pass bandwidth appears appear at both
outer edges. If the passband of the filer for the shift operation is wider than the display area, a
triangle appears.
C
MAIN
/
Shows the selected band, either the main band or the sub band. {page 4-7}
USB
Displays the operating mode in use. Appears in yellow while Auto Mode is active.
Displays the mode name and the sub number (-D1, -D2 and -D3) while in the DATA mode.
{page 4-10}
or
Appears coupled with the frequency while either RIT or XIT is active. {page 5-13}
M.SCR
Displays while scrolling the memory channels. {page 10-4}
Appears while transmitting or receiving using the operating information from a memory channel. {page 10-4}
Appears while in Dual Memory Channel mode. {page 10-4}
Appears while in Quick Memory Channel mode. {page 10-8}
VFO
Appears while in VFO mode. {page 10-4}
00
Shows E0 to E9 in the entry history display, 00 to 99 for M.CH or M.SCR, and Q0 to Q9 for Quick
Memory Channel as the channel number.
{page 10-8}
D
Displays the frequency difference between the main band frequency and the sub band
frequency. Appears while in Split mode.
{page 5-1}
E
Displays a dial. (Displays while only main band frequency in the standard mode is selected.)
Displays the sub band frequency while both the main band frequency and the sub band
frequency are displayed.
{page 4-4}
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Dual Frequency Display
(Main Band Frequency and Sub-band Frequency)
Ⓔ
Single Frequency Display
(Main Band Frequency/Dial)
Note:
◆ Pressing [S.DISP/SEL] changes the sub screen displays. Refer to "BASIC OPERATIONS" for further details. {page 4-4}