GPS – 3
TRACK LOG
All movement is saved in the GPS Logger (
Internal GPS only)
.
Saved information includes latitude, longitude, altitude, travel
direction, speed, time, and date. The log can retain up to 5000
points of data.
Press
[LOG]
to turn the Track Log function On or Off.
When turning the Track Log function On, “LOG START” appears
for approximately 5 seconds, followed by the “
” icon.
•
When turning the Track Log function Off, “LOG STOP” appears on
the display for approximately 5 seconds.
•
With the Track Log function On, even if the power source is turned
Off during a Log acquisition, the log is backed up so that when the
power is turned back on, the log acquisition resumes.
•
You can verify the Log activity ratio in the GPS pinpointing screen.
Note:
◆
When the Track Log is turned On while the GPS is Off, the GPS will also
turn On.
◆
When the GPS is not pinpointing, data is not saved to the log.
◆
You can read the Track Log using the MCP-6A.
◆
If the Track Log overwriting confi guration is turned Off (see below), “LOG
FULL” appears when the log memory is full.
◆
When the APRS is On, Log operation will begin only when the APRS menu
COM terminal input is Off.
■
Track Log All Clear
1
Press
[ALLCLR]
.
•
“CLEAR ALL?” appears. Press the
Tuning
Control to clear all
Track Logs.
■
Overwriting the Track Log
When the Track Log becomes full, new data will begin
overwriting the oldest Track Log data.
1
Enter Menu mode and access Menu 502.
2
Select “ON” or “OFF”.
•
Selecting “ON” will allow old data to be overwritten with new
data.
LOG SETUP
Enter Menu mode and access Menu 503.
■
Record Method <RECORD METHOD>
You can set the conditions for saving Track information as
GPS Logger.
You can change the settings for travel speed, etc.
Select “TIME”, “DISTANCE”, or “BEACON” for the Record
Method.
■
Interval Time <INTERVAL>
Select an Interval time from 2 ~ 1800 seconds (in steps of 1
second).
•
The Interval setting is available only if the Record Method has
been set to “TIME”.
■
Distance <DISTANCE>
Select a Distance from 0.01 ~ 9.99 (in steps of 0.01).
•
The Distance setting is available only if the Record Method has
been set to “DISTANCE”.
•
The units used for Distance can be set to miles (mi), kilometers
(km), or nautical miles (nm).
Interval and Log Total Time:
Point
Qty
Interval time (seconds)
2
5
10
15
30
1800
5000
166.7
416.7
833.3
1250
2500
150000
(min)
2.8
6.9
13.9
20.8
41.7
2500
(hour)
Interval and Total Distance:
Point
Qty
Interval distance (km)
0.01 0.10
2.00
4.00
6.00
8.00
9.99
5000
50
500
10000
20000
30000
40000
49950
(km)
