Kenwood Slimline KDW45B13, Руководство по установке

Страница: 29 / 36

29
spray arms
Particles of food can get stuck in the spray arm jets and
bearings. The spray arms should therefore be checked
and cleaned regularly.
1. Ensure the dishwasher is switched off.
2. Check whether or not the holes for the upper and
lower spray arms are clogged. If there is any clogging,
remove the spray arms and clean them under running
water.
3. You can remove the lower spray arm by pulling it
upwards, while the upper spray arm nut can be
removed by turning the nut to the left.
4. Be sure that the nut is perfectly tightened when
refitting the upper spray arm.
frost precaution
Avoid placing the dishwasher in a location where the temperature can get below 0°C. If your
appliance is left in an unheated place over the winter, you are advised to:
5. Disconnect the unit from the water inlet.
6. Turn on the unit. Select any washing cycle and let it run for 1 minute only. This drains out all the
excessive water that remains in the unit.
7. Disconnect from the mains socket.
8. Empty the dishwasher.
9. Close the dishwasher’s door.
10. Disconnect the unit from the water drain. Use a suitable receptacle to catch any residual water in
the pipes.
Should you encounter any difficulties with the above steps, please ask a service technician for
assistance.
moving the dishwasher
If you have to move the unit, for instance due to moving house, you are advised to:
1. Disconnect the dishwasher from the mains.
2. Disconnect the dishwasher from the water inlet and drain. Use a suitable receptacle to catch any
residual water in the pipes.
3. Remove the dishwasher from the current location with the hoses discharged.
4. Pull the unit out together with the hoses.
• Avoid over tilting the unit during transportation.
• We recommend that 2 people handle the dishwasher during installation.