Kenwood PKT-23, Инструкция по эксплуатации

Страница: 18 / 32

10
Voice Announcement
Enable Disable
Ch. No. LED Vo. Ann. LED Bl. LED Bl. and T. So.
5
Blue
"Five" 1 1
6 "Six" 2 2
7 "Seven" 3 3
8 "Eight" 4 4
• After selecting a channel, the channel number is announced
when Voice Announcement is enable or the Channel Select
Tone sounds when Voice announcement is disable. Regardless
of the Voice Announcement confi guration, the LED indicator
blinks to indicate the current channel number.
For example, to indicate the channel number 5, the LED
blinks blue once and a voice announces “Five” when Voice
Announcement is enable, and the LED blinks blue once and a
Channel Select Tone sounds once when Voice Announcement
is disable.
• Press the PF-2 key to switch between Volume Adjustment
mode and Channel Select mode.
2 To make a call, press and hold the PTT switch, then speak
into the microphone using your normal speaking voice.
• Hold the microphone approximately 1.5 inches (3 to 4 cm) from
your mouth.
3 Release the PTT switch to receive.
Note:
◆
When the battery pack voltage becomes too low, transmission
will stop and an alert tone will sound. (Low Battery Warning:
While operating the transceiver, the Low Battery Warning
sounds an alert tone every 30 seconds and the LED indicator
blinks red when the battery needs recharged or replaced.)
◆
Even when setting the volume to 0, the transceiver will continue
to emit beep sounds and channel announcements.
◆
Continuously transmitting when the transceiver becomes too
hot will cause the output power to decrease and may eventually
stop transmission. Stop transmitting for a while to allow the
transceiver to cool down.